What should be done if the dispensing size of the glue machine is inconsistent?
View count:2021-02-02 View count:301
What should be done if the dispensing size of the glue machine is inconsistent? The manufacturer of HOLS(Suzhou) glue machine
answers your questions:
When the glue output of the glue machine is inconsistent, it is mainly caused by the
unstable pressure cylinder or air pressure of the stored fluid.
1. The inlet pressure regulator should be set 10 to
15 psi lower than the low pressure in the factory The pressure used in the pressure cylinder should be between the
middle and above of the pressure gauge, and the use of pressure between the low pressure part of the pressure gauge
should be avoided
2. The control pressure of the glue valve should be at least 60psi or above to ensure stable glue discharge3. The
dispensing time should be checked. If it is less than 15/1000 seconds, it will cause unstable dispensing The longer
the dispensing time, the more stable the dispensing becomes